Open Map
Close Map
Projections and Nav Modes
  • Normal View
  • Fisheye View
  • Architectural View
  • Stereographic View
  • Little Planet View
  • Panini View
Click and Drag / QTVR mode
Share this panorama
For Non-Commercial Use Only
This panorama can be embedded into a non-commercial site at no charge. Read more
Do you agree to the Terms & Conditions?
For commercial use, contact us
Embed this Panorama
For Non-Commercial Use Only
For commercial use, contact us


Crimson Wash Mine - upper adit [1]

The Crimson Wash Mine is an abandoned talc mine in the Eureka Valley area of California.  There are two adits of short length, this is the upper one with a crosscut through limestone/marble adorned with ore cart tracks rounding a corner & leading to this ore chute about 300 feet within.  If you go behind the ore chute you will find an incredible stope still amidst a massive vein of talc.  Because talc is soft & unstable, the entire workings are reinforced with square set stoping.  Even at this location, the ceiling has been identified as unstable to which support beams are mounted all throughout, however there hasn't been a major cave-in yet!


A few mining terms:


Adit - A horizontal passage leading into the mine, not to be confused w/ a "tunnel", which would have an opening out the other side.  Adits are sloped slightly upwards to allow for drainage of groundwater.


Crosscut - A horizontal opening that does not run along the vein. Typically a shaft will lead to crosscuts at each level that give access to drifts along the vein. Crosscuts typically run straight as an arrow through worthless rock.


Drift - A horizontal opening that runs along the vein. Typically there are many ore chutes from stopes above, and the drift will wander to follow the vein.


Level - If you follow a ladder down a shaft, you will arrive at horizontal workings every 100 feet or so, and these are called levels. The levels have a station near the shaft, and are named by the distance down the shaft.


Manway - Any kind of passage with a ladder in it could be called a manway. Shafts are divided into "compartments" and one of these is very often a manway. Sometimes the manway of a shaft is crowded with pipes and cables and such.


Ore chute - A "spout" built of wood used to load broken rock from above into waiting ore bins.


Raise - A raise is like a shaft that starts undergound and goes upwards. Typically a ladder next to an ore chute along a drift goes up a raise and gives access to a stope above.


Square set stoping (timbering) - The most expensive mode of underground mining. As ore is removed in a stope, it is replaced by a 10x10 foot lattice of 12x12 timbers. The ground was unstable here & the lattice helps protect from potential collapses. Many times the sets are backfilled with broken rock to help support the stope.


Stope - An excavation underground that actually removed whatever it was they were after. These are typically irregular in shape as they follow the ore whereever it goes. If the vein is wide and/or the rock is poor, the challenge in mining is to keep the rock supported while extracting the material in the stope.


Winze - A winze is like a vertical or inclined shaft that starts underground & connects one level down to another.



Source: Mining Terms:

Copyright: William L
Type: Spherical
Resolution: 13200x6600
Taken: 26/06/2019
Uploaded: 05/07/2019
Updated: 31/12/2019


Tags: crimson wash; mine; california; talc; adit; drift; crosscut; ore chute; ore cart tracks; tunnel; shaft; rail; eureka valley
More About California

It looks like you’re creating an order.
If you have any questions before you checkout, just let us know at and we’ll get right back to you.